Power Developer

Auto boot-up after power restore
Page 1 of 1

Author:  lmayer [ Fri Feb 24, 2012 1:05 pm ]
Post subject:  Auto boot-up after power restore

I saw someone wrote in a similar question last year about September. I'm wondering, though, if any solution has been found to make the efika i.mx smarttop boot after ac power is restored following a power outage?

Even a simple hardware alteration?


Author:  PurpleAlien [ Fri Feb 24, 2012 1:18 pm ]
Post subject: 


Send me an email... (johan <dot> dams <at> genesi-usa.com )


Author:  brainstorm [ Mon Feb 11, 2013 12:00 pm ]
Post subject:  Re: Auto boot-up after power restore

I'm interested in this too!

Author:  brainstorm [ Sun Feb 17, 2013 5:04 pm ]
Post subject:  Re: Auto boot-up after power restore

Turns out that a hardware change is required, but it is minimal. Shorting a jumper (JP8903) in the board does the trick.

After unmounting the device, that jumper can be found just behind the mic connector in the bottom side of the board.

Genesi can not be held liable for any damage that may occur, perform this mod at your own risk!!!

Page 1 of 1 All times are UTC-06:00
Powered by phpBB® Forum Software © phpBB Group