In theory
http://www.powerdeveloper.org/asset/by-id/116 should update the old TO2 smarttop too. In practice I get:
Code:
U-Boot 2009.01-1.1.7-efikamx (Dec 21 2009 - 14:00:56)
CPU: Freescale i.MX51 family 2.5V at 400 MHz
mx51 pll1: 800MHz
mx51 pll2: 665MHz
mx51 pll3: 216MHz
ipg clock : 66500000Hz
ipg per clock : 665000000Hz
uart clock : 66500000Hz
cspi clock : 54000000Hz
Board: Genesi Efika MX [POR]
DRAM: 512 MB
JEDEC ID: 0xbf:0x25:0x4a
Reading SPI NOR flash 0x40000 [0x10000 bytes] -> ram 0x975f06e8
.SUCCESS
In: serial
Out: serial
Err: serial
Boot Source: SPI NOR FLASH BOOT
board rev1.1
SD card.
Vendor: Man 27 OEM PH "SD04G" Date 02/2009
Product: 2088767390
Revision: 2.0
board rev1.1
SD card.
Vendor: Man 27 OEM PH "SD04G" Date 02/2009
Product: 2088767390
Revision: 2.0
No Fat FS detected
reading type_id.bin
** Unable to read "type_id.bin" from mmc 0:1 **
Type ID = 0
Boot Cmd: run pata_boot
Hit any key to stop autoboot: 0
I put
type_id.bin there manually, but no luck...