Lame arsed newbie question:

No volumes are showing up in the installer, although I added blckdev /dev/hda3 -rw -force to the molrc.osx
I'm using kernel 2.4.25, MOL 0.9.70 and OSX 10.3

What could be the problem !?

Perhaps it will work better with MOL 0.68.

you typed it exactly like that?

try :

blkdev: /dev/hda3 -rw


remember the ":"

Im having the exact same problem only im running MOLK.
Installation cd boots fine, but no drives show up in the installer or disk utility.
I have tried just mounting the specific partition and the whole disk, aswell as all disks ... with -rw ... nothing turns up.

Alright, -force solved at least my problems, and someone COULD have told me i have to reboot after partitioning in the osx installer. =P
Now i have the network problem though.
Since its MOLK.

Has ANYONE got networking in OSX to work in MOLK ?

@corpsicle

>Has ANYONE got networking in OSX to work in MOLK ?

Yes! SEVERAL PEOPLE!
the molk-version uploaded atm was/is a wip so
better wait for the next release...

frostwork

Oh, so should i get an older version ?
Or is there a way to get this version i have to work ?
If you could point me to any download sites/howtos/anything that might help me get it to work i would be eternally grateful. =)


Also, why didnt you tell me you created MOLK ? =D
Hopefully you if anyone can help me get networking running somehow.

Hi, corpsicle!

MOLK-0.6 is ready for download on pegasos.org :)
Many improvements! :)

I'm afraid I'm the worst person who could help you with network stuff :(
But maybe it helps to read the mol Documentations in the Docs-mol dir...
Good luck so far!
frostwork