Is the manual for the Pegasos 1 available for download anywhere (I can only find the manual for the PegII on the Genesi site). I just bought a Peg1 off eBay and need to know the details for the headers on the board so I can hook up the power and reset buttons etc.
Also, does the PPC750 aka G3 chip run fanless or does it require a 40mm commonly used on GPUs and northbridges?

Thanks,
Edward

All the pins and headers are identical.

The G3 is fanless.

Thanks Neko, I think it must have been a bit of a surpise for you to see me over "this side". Truth is AmigaOne's aren't available and this was just too cheap to miss out on.
Also, is there a misprint in the PegII manual or does the Marvell II northbridge really support "100 gigabit networking"? :wink:

The numbers are swapped:

The Marvell internal Crossbar bandwidth is 100(+) Gbit/s and the Gigabit port is - of course - 1 Gbit/s.